integration of the board on the detector was done at GSI-DTL in 2020. Mesytec FAIR MUSIC amplifier board v.1 (May 2020). Following the results, the production of the Super-FRS First of Series started, as stipulated

the main separator and the ends of the branches [1]. The use of materials which survive Super-FRS beam rates longer than plastics (typically lifetime 1 week) is under investigation. As start/stop detector [...] synchronized with a 200 MHz external clock. [1] C. Nociforo, 2014 JINST 9 C01022 A ToF resolution of 40 ps, well in agreement with the goal design, was measured with DD1 and DD2 detectors close each other using [...] geometry 20x20x0.3 mm 3 have been tested at the FRS. They have been equipped with 16 vertical strips of 1 mm width separated by a gap of 0.15 mm. The Cr/Au electrode metallization (50/100 nm) via photolithography

efficiency. The GEMEX1c electronics was used to test. In 2016 a new version of the digital readout electronics GMX based on NYXOR and DNF boards was develped and tested with ion beams [2]. [1] F. Garcia et al [...] (prototypes) have been constructed and tested in 2011, 2012 and 2014 with relativistic ion beams [1]. The lastest has a twin configuration, i.e. two GEM-TPC detectors flipped (with the electric fields

acceptance of the separator, a large dynamic range, and will operate at rate as high as possible, typically 1-10 MHz. The identification in charge number Z and mass number A is accomplished by a combined event-by-event [...] Simulated A/q distributions at the end of the Main-Separator of 235-237U (yields not scaled) at about 1.4 GeV/u assuming sigma_x = 0.5 mm and sigma_ToF = 20 ps. slides PID 2019

used for tune determination. A standard GSI monitor DG1010 designed with wire spacing of 1.5 mm and diameter of 0.1 mm was installed in vacuum at the FRS and irradiated with uranium beams in 2014. To simulate

sensitive housing with stainless steel foils (0.1 mm) separating it from the vacuum. The IC analogue signal was fed into a current to frequency converter. [1] S. Schlemme et al., GSI Scientific Report (2015) [...] Two-gap IC with active area of 50 mm diameter. Intensity curve measured for 12C at 62 MeV/nucleon [1]. At the highest particle rates it is foreseen to operate a SEM transmission monitor equipped with thin [...] the pcCVD-DD signals as a function of the irradiation time at two different beam attenuation factors f1 and f2. [3] S. Schlemme et al., Diam. Relat. Mater. 99 (2019) 107536 The counting efficiency of a a

Also beam stoppers or diffusers are included in Super-FRS the beam line. slides IDPASC 2103 (part 1) slides IDPASC 2013 (part 2) contact

heggen(at)gsi.de Post address Henning Heggen - EEL Gesellschaft für Schwerionenforschung Planckstr.1 D-64291 Darmstadt GERMANY

Academy of Sciences, Cracow, Poland 1 month within Sep, 2017 - Dec, 2017 at GSI Ameresh Jaiswal, National Institute of Science Education and Research (NISER), Jantni, India 1 month within Sep, 2017 - Dec, 2017

pre-pulses generated in this way can be up to 10 ns before the main pulse with energy ratios of up to 1:1. Figure 1: Measurement of the temporal contrast at the femtosecond front end with ultrafast parametric amplifier [...] amplifier (blue). The prepulses marked with arrows are artefacts of the measurement system. [1] Reference: [1] Y. Zobus, et al., High Power Laser Science and Engineering Vol. 11, e48 (2023), doi:10.1017/hpl [...] temporal contrast of the femtosecond front end a few ns before the actual pulse is shown in Figure 1. In addition, the contrast can be tailored to the special requirements of different experiments with